产品

HS6201

Introduction

The HS6201 is designed for operation in the world wide ISM frequency band at 2.400 - 2.4835GHz. To design a radio system with the HS6201, you simply need an MCU (microcontroller) and a few external passive components. You can operate and configure the HS6201 through a Serial Peripheral Interface (SPI). The register map, which is accessible through the SPI, contains all configuration registers in the HS6201 and is accessible in all operation modes of the chip.

Features

Radio:

 Worldwide 2.4GHz ISM band operation

 126 RF channels

 Common RX and TX interface

 GFSK modulation

 500kbps, 1 and 2Mbps air data rate

 1MHz non-overlapping channel spacing at 1Mbps

 2MHz non-overlapping channel spacing at 2Mbps

Transmitter:

 Programmable output power: 10, 17, 22 or 25dBm

 Max output power: 25dBm(3.3V @260mA)

 140mA at 17dBm output power

 Small-Signal Gain:21dB

Receiver:

 Fast AGC for improved dynamic range

 Integrated channel filters

 19.5mA at 2Mbps

 -83dBm sensitivity at 2Mbps

 -88dBm sensitivity at 1Mbps

 -88dBm sensitivity at 500kbps

RF Synthesizer:

 Fully integrated synthesizer

 No external loop filer, VCO varactor diode or resonator

 Accepts low cost ±60ppm 16MHz crystal

Protocol engine:

 1 to 32 bytes dynamic payload length

 Automatic packet handling

 Auto packet transaction handling

 6 data pipe for 1:6 star networks

Power Management:

 Integrated voltage regulator

 1.8 to 3.6V supply range

 Idle modes with fast start-up times for advanced power management

 30µA Standby-I mode,4µA power down mode

 Max 2ms start-up from power down mode

 Max 210us start-up from standby-I mode

Host Interface:

 4-pin hardware SPI

– Max 10Mbps

 3 separate 32 bytes TX and RX FIFOs

 5V tolerant IO

 

Figure1: QFN20 4x4 package (top view)

Applications

 Wireless mouse/keyboard

 Wireless audio

 General remoter

 RC toy

 RFID

 

 

中科汉天下电子有限公司 © 2014 版权所有   powered by Minethink京ICP备12042624 Copyright 2014 Auto Parts All Right Reserve